Can You Mix Different Perler / Fuse Bead Brands?

Melting points differ by factory

Many shops source from a few major factories (commonly discussed lines include Baisu / 百塑 and Youken / 优肯; some brands run their own plants with similar melt behavior). Ask customer service which factory your bag comes from before mixing.

When melting points differ on one board, ironing becomes guesswork: uneven melt, warped edges, and “soft vs hard” cells in the same piece.

Quality varies — technique is not always the villain

Stock shortages are rarer now at major shops, but quality still varies: uneven bead height, inconsistent melt, and bag-to-bag color shift.

If an ironed piece looks bad, consider bead quality — not only ironing skill — before blaming yourself.

Color difference is real — even if hard to see

Competition makes many shops claim “no color difference.” In practice, even batches from the same shop can shift slightly.

Differences that look tiny in the bag can become obvious after ironing, especially under daylight. As a rule, do not mix leftover colors across shops or batches into one jar.

White beads: never mix

White is the color where batch mismatch shows most after fusing. Unironed bags may look identical; finished pieces can look patchy — often dramatically.

Rule of thumb: buy white from one batch, use it down, then open the next. Do not pour leftover whites from different bags into one jar.

• Prefer one factory per project
• Never mix white beads across shops or batches
• If you must mix other colors, accept risk and test a small sample first

Pattern tip

Generate your 拼豆图纸 with the palette you actually own. PixelBeads color counts help you restock the same codes instead of substituting randomly.